Azza Z Manuel d'utilisateur télécharger pdf (Page 7)

7.1 Install the I/O cover on the rear side of the chassis.

7.2 Place the motherboard into the slot as shown in the

figure, and fasten the screws.

7.Motherboard Installation

9.1 A Cooling system bracket is provided that accommodates

the installation of 120 / 240 mm water cooling system.

9.Cooling System Installation

Maximum 240 mm

120 mm

8.1 loosen the screw, and remove the VGA holder.

8.2 Install the VGA Card, and fasten the screws.

8.3 Remove the sticker(s) and paste the rubber pad(s) on the VGA holder if necessary.

8.4 Put VGA holder back, and connect the PCI-E cable.

8.VGA Card Installation

6.ODD (BD/DVD-ROM) Installation

6.1 Insert the ODD device, and fasten the screws.

1 2 3 4 5 6 7 8

Pas de commentaire

Azza Z Manuel d'utilisateur Page 7